10K NTC Thermistor 1% Epoxy Thermistor
10K NTC Thermistor overview
Need to measure something damp? This epoxy-coated 10K thermistor is an inexpensive way to measure temperature in weather or liquids. The resistance at 25 °C is 10K (+- 1%). The resistance goes down as it gets warmer and goes up as it gets cooler. These are often used for air conditioners, water lines, and other places where they can get damp. The PVC coating of the wires is good up to 105 °C so this isn’t good for very hot stuff.
We even toss in an additional 1% 10K resistor which you can use as a calibration or for a resistor divider. NTC 100k±1% 3950 Temperature Sensor Probe Thermometer (25mm) Waterproof, Thermistor NTC 10K Accuracy 1% Waterproof Probe, Temperature Sensor Probe Thermometer, NTC 100k±1% 3950, Thermistor NTC 10K Accuracy 1%.
Key specifications
Datasheet
10K NTC Thermistor features
- Measure Environmental temperatures using Arduino ADC and this 10K NTC
- Resistance to the temperature conversion table
- Wide resistance range
- Cost-effective
- Tinned copper leads
- Lead spacing 5.0 mm
- Marked with resistance and tolerance
- Typical Dissipation Constant 5mW/ °C
10K NTC Thermistor specifications
| Measurement range | -20 to 105 °C |
|---|---|
| Length of wire | 8 inches approximately. |
| Size of probe | 5 x 25 mm |
| Output | 2 wires |
| Type | NTC 10k±1% 3950 |
| B-constant | 3380K -/ 1% |
| Probe insulation | >100MOhm |
| Peak Voltage sustain time | 2 seconds, AC1800V 1mA 2 seconds |
| Stress sustain | 9.8N (1kgF) for 1 minute no deformation |
Comments 0
Leave a comment