The HCA10014 is a 15MHz/ BiMOS Operational Amplifier with MOSFET Input/CMOS Output made by Intersil Corporation, supplied in an SOP 8 Pin Type package. The absolute maximum ratings table on this page lists the 3 limits from the manufacturer's datasheet that must not be exceeded. This page brings together the HCA10014 pinout and maximum ratings, with the full datasheet PDF to preview below or download.
HCA10014 op amp combines the advantage of both CMOS and bipolar transistors.
Gate protected P-Channel MOSFET (PMOS) transistors are used in the input circuit to provide very high input impedance, very low input current, and exceptional speed performance. The use of PMOS transistors in the input stage results in common mode input voltage capability down to 0.5V below the negative supply terminal, an important attribute in single supply applications.
A CMOS transistor pair, capable of swinging the output voltage to within 10mV of either supply voltage terminal (at very high values of load impedance), is employed as the output circuit.
The HCA10014 operates at supply voltages ranging from 5V to 16V, (±2.5V to ±8V). It can be phase compensated with a single external capacitor, and have terminals for adjustment of offset voltage for applications requiring offset null capability. Terminal provisions are also made to permit strobing of the output stage.
Datasheet
hca10014-datasheet.pdf
Format PDFSize 522 KBLanguage ENRevision File No. 4769
Ideal for Single Supply Applications Common Mode Input Voltage Range Includes Negative Supply Rail; Input Terminals can be Swung 0.5V Below Negative Supply Rail
CMOS Output Stage Permits Signal Swing to Either (or both) Supply Rails
Ground Referenced Single Supply Amplifiers
Fast Sample and Hold Amplifiers
Long Duration Timers/Monostable
High Input Impedance Comparators (Ideal Interface with Digital CMOS)
High Input Impedance Wideband Amplifiers
Voltage Followers (e.g., Follower for Single Supply D/A Converter)
Voltage Regulators (Permits Control of Output Voltage Down to 0V)
Comments 0
Leave a comment